Panasonic KX-TEM824 Features Manual page 147

Status
FWD to Extension Ringback
Tone
System Programming
The following settings to enable Inband (DTMF) Integration must be programmed through system
programming to match the settings of the VPS. This example uses a Panasonic KX-TVP series VPS, which
can be connected to up to 4 extension jacks of the PBX.
[Programming Example: Voice Mail Table]
DTMF Integration*
Enable
1 DTMF Integration [103]
*
2 DTMF Integration Port [102]
*
3 Extension Number [009]
*
In this example:
To enable the VM Hunting Chain and AA Hunting Chain, programme as follows:
1)
Assign all Voice Mail extensions to one extension group in Extension Group [600].
2)
Assign "Enable" to the group in Hunting Group Set [100].
3)
Select the hunting type of the group in Hunting Type [101].
VM Service
1.
Accessing a Mailbox
The PBX sends DTMF signals to the VPS to indicate which mailbox should be accessed (Follow-on
ID).
2.
Listening to Recorded Messages
After the VPS records a message, it will light the appropriate lamp or button on the extension for which
the message was intended, to indicate that there is a new message (
proprietary telephone (PT) user can play the message back simply by pressing the MESSAGE button
used for mailbox access. When the button is pressed, the PBX calls the voice mail extension, then
sends DTMF signals to the VPS to indicate the extension's mailbox number.
A single line telephone (SLT) user hears a special dial tone (dial tone 3) when going off-hook if there
are any messages in his or her mailbox, and can play the message back by entering the Message
Waiting Answer feature number.
Conditions
• A VPS can be assigned as the destination for the following features:
The PBX is calling an extension other than the
one dialled, most likely because the called
extension has set its calls to be forwarded to
another extension or because it is a member of
an idle extension hunting group (
Extension Hunting).
Voice Mail Port*
1
Jack 07 Jack 08
Enable Enable
Condition
1.2.1 Idle
2
Jack 15 Jack 16
Disable Disable
1.19 Voice Mail Features
DTMF Status Signal
8
Numbering Plan*
Plan 1 or Plan 2
1.17.1 Message Waiting). The
Feature Guide
3
147