Do you have a question about the WN and is the answer not in the manual?
Questions and answers
Phillip Merriman
February 20, 2025
how do you change a door hinge on an Esse 990WN/WD
2 comments:
Mr. Anderson
February 20, 2025
To change a door hinge on an Esse 990WN/WD:
1. Remove Locking Grub Screws – Use a 3/16” Allen key to remove the upper and lower locking grub screws from the hinges. 2. Adjust Eccentric Pins – Using the same Allen key, adjust either or both eccentric pins in each door hinge to level the door. 3. Secure the Pins – Once the door is level, lock the eccentric pins in place by tightening the locking grub screws.
This ensures the door is properly aligned after hinge replacement.
This answer is automatically generated
Phillip Merriman
February 20, 2025
@Mr. Anderson
It is the door hanger that I need to change, which is attached to the front of the main cooker. It is the threaded bar that the door hinge screws onto.
How is the threaded bar attached to the cooker, can it be removed from the body of the cooker by simply unthreading it?
INTRODUCTION THE IMPORTANCE OF A HEALTHY FLUE The successful operation of your Woodfired range cooker is entirely dependent on the adequate performance (pull) of the chimney or flue to which it is connected. The following maintenance By burning properly guidelines will be pointless unless the flue is also maintained and cleaned regularly. How often it needs cleaning will depend on the quality and moisture content of the wood you burn but an annual clean is recommended.
Page 3
CLEANING THE FLUE WAYS - Every 3 months Always carry out cleaning procedures when the cooker is out and has been allowed to cool sufficiently to avoid burns. With time and experience you will be able to gauge the intervals between flue way cleaning more accurately.
CLEANING THE EXIT FLUE - Every 12 months It is essential to maintain the integrity and cleanliness of the flue to ensure that your cooker continues to perform at its best. When your cooker was installed the main flue should have been equipped with an inspection hatch;...
Page 5
The Woodfired cooker’s firebox is designed to operate at very high temperatures to burn the gases and CHOOSING THE RIGHT WOOD & WOOD BURNING GUIDELINES particles released from the wood, which means less air-pollution. The air supply to the afterburner in your cooker is always open but works most effectively in conjunction with a hot fire.
they will fur up the chimney with creosote more easily than a hardwood like oak. This is not necessarily to make a dull "thud" when struck. true at all. It is not the pitch that is the problem, it's the water IN the pitch. Once the water in the wood has Another thing you can do to help is store your wood properly.
Need help?
Do you have a question about the WN and is the answer not in the manual?
Questions and answers
how do you change a door hinge on an Esse 990WN/WD
To change a door hinge on an Esse 990WN/WD:
1. Remove Locking Grub Screws – Use a 3/16” Allen key to remove the upper and lower locking grub screws from the hinges.
2. Adjust Eccentric Pins – Using the same Allen key, adjust either or both eccentric pins in each door hinge to level the door.
3. Secure the Pins – Once the door is level, lock the eccentric pins in place by tightening the locking grub screws.
This ensures the door is properly aligned after hinge replacement.
This answer is automatically generated
@Mr. Anderson It is the door hanger that I need to change, which is attached to the front of the main cooker. It is the threaded bar that the door hinge screws onto. How is the threaded bar attached to the cooker, can it be removed from the body of the cooker by simply unthreading it?