Erasing Single Images; Erasing All Images - RCA CDS1005 User Manual

Adjusting Settings
Note: For information about putting
pictures on a computer, see the
Software section of this manual.

Erasing Single Images

When an image has been loaded onto a
computer or is no longer wanted, it can
be erased from memory, freeing up
space for additional pictures.
When erasing, it might be a good idea
to have the camera connected to the TV
with the video serial cable (see the
previous step, Viewing Images).
1. Make sure that the camera is turned
on and is in playback mode (
2. Press and hold the menu button (
until the erase single image icon
( ) is displayed and flashing in the
lower right-hand corner of the LCD.
3. Choose the image number that you
want to erase by using either the
EV/+ or /– buttons to make the
selection.
4. When the correct image number is
displayed on the LCD, press the
shutter release button on top of the
camera to OK erasing the picture.
Note: Another image can be selected
with the EV/+ or /– buttons and erased
following the above steps.
12

Erasing All Images

An alternative to erasing images one at
a time is to erase all stored images at
once. To do this, use the Erase All
command.
1. Make sure that the camera is turned
on and is in playback mode (
2. Press and hold the menu button (
until the first icon is displayed and
flashing in the lower right-hand
corner of the LCD.
3. Press the menu button (
to advance to the next icon, Erase
All (
).
4. When the Erase All (
)
displayed and flashing on the LCD,
press the shutter release button to
OK the erasing of all stored pictures.
Notes:
While the camera is processing,
uploading, or erasing images, the
green LED light located on the back
of the camera flashes. While the
green light is flashing, DO NOT
remove the batteries, remove
power from the camera, turn the
camera off, disconnect the camera
from a computer, or perform any
other operation. This will cause fatal
damage to the operating system of
the camera.
) quickly
).
) icon is
).
)