Selecting The Analog Or Digital Input Mode; Changing The Decode Mode - JVC TH-A10 Instructions Manual

Basic operations
Selecting the analog or digital input
mode
When you have connected some components such as MD recorder, the
DBS tuner and so on, using digital terminals (see page 9), you need to
change the input mode for these components to the digital input.
You can choose digital sound from the following sources: "MD",
"DBS", "AUX".
Primary remote control only:
2
1.
Press the source selecting button (TAPE/MD, AUX,
or TV/DBS) for which you want to change the input
mode from analog input to digital input.
Example: Selecting MD recorder as the source for digital audio.
2.
Press ANALOG/DIGITAL INPUT.
The display changes as shown below each time the button is
pressed.
= AUTO/PCM = DOLBY DGTL (DOLBY DIGITAL) = DTS =
ANALOG = (back to the beginning)
3.
Press ANALOG/DIGITAL INPUT to select
[AUTO/PCM].
• The source name changes from "MD" to "MD DIGITAL".
When other than [AUTO/PCM] is selected
When "DOLBY DGTL" or "DTS" is selected the source name
changes to digital ("MD" = "MD DIGITAL") and audio is not
played.
The decode mode indicator "DOLBY DIGITAL" or "DTS" in the
display window flashes to indicate that the correct mode has not
been selected.
Example: Selecting "DOLBY DGTL" when listening to MD
with digital audio.
Flashes
18
1
«
After approximately 3 seconds
To return to analog audio
1. Select a digital source to return to analog audio.
Select from "MD DIGITAL", "AUX DIGITAL", or "DBS
DIGITAL".
2. Press ANALOG/DIGITAL INPUT to select [ANALOG].
Analog audio is selected and the source name also returns to
analog.
Note:
• When selecting a digital source, press ANALOG/DIGITAL
INPUT once to display the currently selected mode.

Changing the decode mode

Primary remote control only:
1
2
1.
Press DVD to select DVD as the source.
2.
Press ANALOG/DIGITAL INPUT to select the
decode mode.
The display changes as shown below each time the button is
pressed.
= AUTO/PCM = DOLBY DGTL (DOLBY DIGITAL) = DTS
= (back to the beginning)
AUTO/PCM
Optimized for all discs playable on this
system. (Default)
DOLBY DGTL Select this mode when playing a disc
recorded in Dolby Digital Surround.
DTS Select this mode when playing a DVD disc
recorded in DTS Surround.
The DTS decoder will be selected as the
internal decoder.
When to try changing the decode mode
When the decode mode is set to the default AUTO/PCM setting and
a DVD recorded in Dolby Digital Surround or DTS Digital Surround
is played, the internal decoder will be automatically selected before
audio playback begins. Depending on the disc, this may result in a
brief loss of audio after playback starts. This is due to lost audio
signals that were inputted during internal decoder selection.
In these instances, lost audio can be prevented by manually selecting
the decode mode appropriate for the disc you wish to play.
However, please note that when the decode mode is set to other
than AUTO/PCM, you will be unable to playback audio from discs
recorded in a mode other than the set mode.
After changing the decode mode and playing back a disc, return the
decode mode to "AUTO/PCM".
Changing the playback source will automatically set the decode
mode to "AUTO/PCM".