2.11.1 MAGIC FOCUS Character Set-Up
This instruction should be applied when a new DCU
is being replaced.
Adjustment Preparation
(1) Receive NTSC RF or video signal.
(2) With Power off, PRESS and HOLD the SERVICE
ONLY button on DEF./CONV. PWB, then press the
Power On/Off, when picture appears release
SERVICE ONLY switch (Internal crosshatch is
displayed without conv. correction data).
(3) Set R/C to DCAM mode (refer to page 47).
(4) Press the DAY/NIGHT button 2 times for ROM READ
operation.
Picture will appear with convergence
correction data.
Adjustment Procedure
(1) Press
key on R/C. (One additional line appears
near the top and near the bottom.)
(2) Press
key, then ADJ. PARAMETER mode is
displayed as following.
ADJ. PARAMETER
ADJ. DISP.:
0F
DEMO WAIT: 1F
GUIDE
INT. START:
13
GUIDE
V. SQUEEZE: 10
(3) Press CURSOR PAD
or
to change the ADJ.
DISP. data.
(4) Press CURSOR PAD
to access DCU parameter.
Change the data as shown on Table 1, DCU
Parameter.
(5) Press Aspect key 2 times to write changed data into
EEPROM. (First press ADJ. PARAMETER/ROM
C.C.
WRITE? is displayed for alarm. 2nd press, writes
C.C.
data into EEPROM.
Green dots appear after
completion of operation.)
(6) Press MUTE/VOLUME key 3 times to exit from ADJ.
PARAMETER mode.