Measurements
These are shown on the drawings. The
depth measurment is critical. The center
line of the supply and discharge piping
should be a maximum of 3-1/16" (78mm)
and a minimum of 2" (51mm) behind the
finished wall surface, including tile. This is
1-1/16" (27mm) of adjustment.
Pipe, ells and nipples are not furnished
with the valve.
CAUTION:
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer nuts are in place. The cartridges and
retainer nuts were probably installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that
through the handling of the valve by any number of persons the retainer nuts may not be properly installed. This should be care-
fully checked at time of rough-in and trim-out. If the retainer nuts are not properly installed, water pressure could force the
cartridges out of the casting. Personal injury or water damage to the premises could result.
TWO HANDLE
TUB & SHOWER VALVE
SPOUT
Always turn water off before disassembling the valve. Open both valve handles to
relieve water pressure and to insure that COMPLETE water shut-off has been accomplished.
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
MT302E
MODEL 72964 Series