Modification Of D Page Data - Sony DCR-PC100 Service Manual

Initial value
Address
NTSC PAL
AF Fixed data-1
B0 (Initialized data)
B1
B2 Fixed data-2
B3 Fixed data-1
B4 (Initialized data)
B5 Fixed data-2
B6 (Modified data. Copy the data built in
the same model.)
B7 Fixed data-1
B8 (Initialized data)
B9
BA
BB
BC Fixed data-2
BD (Modified data. Copy the data built in
BE the same model.)
BF Fixed data-1
C0 (Initialized data)
C1
C2
C3
C4
C5
C6
C7
C8
C9
CA
CB
CC
CD
CE
CF
D0
D1
D2
D3
D4
D5
D6
D7
D8
D9
DA
DB
DC
DD
DE
DF
Table. 5-1-2.
Remark
1-2-2. INITIALIZATION OF D PAGE DATA
1. Initializing the D Page Data
Note: If the D page data has been initialized, the following adjustments
need to be performed again.

1) Modification of D page data

2) Color viewfinder system adjustments
3) LCD system Adjustments
Adjusting page
Adjusting Address
Initializing Method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 3, address: 80, set data: 0D, and press the PAUSE
button of the adjustment remote commander.
3) Select page: 3, address: 80, and check that the data changes to
"1D".
4) Perform "Modification of D Page Data".
2. Modification of D Page Data
If the D page data has been initialized, change the data of the "Fixed
data-2" address shown in the following table by manual input.
Modifying Method:
1) Before changing the data, select page: 0, address: 01, and set
data: 01.
2) New data for changing are not shown in the tables because
they are different in destination. When changing the data, copy
the data built in the same model.
Note: If copy the data built in the different model, the camcorder may
not operate.
3) When changing the data, press the PAUSE button of the
adjustment remote commander each time when setting new
data to write the data in the non-volatile memory.
4) Check that the data of adjustment addresses is the initial value.
If not, change the data to the initial value.
Processing after Completing Modification of D Page data
1) Select page: 2, address: 00, and set data: 29.
2) Select page: 2, address: 01, and set data: 29, and press the
PAUSE button of the adjustment remote commander.
Note: If the following symptoms occur after completing of the
"Modification of D page data", check that the data of the "Fixed
data-2" addresses are same as those of the same model of the same
destination.
1) The battery end mark on the LCD or viewfinder screen is flashing.
2) The power is shut off so that unit cannot operate.
5-10
D
10 to 9F