Checking The Input Signals - Panasonic AJ-HD3700H Operating Instructions Manual

Recording
Simultaneous playback monitoring
∑ Video monitoring
≥Set VIDEO during recording to TAPE on the VIDEO OUT HD SET UP STATE menu.
VIDEO
∑ Audio monitoring
≥Set AUDIO during recording to TAPE on the AUDIO OUT SET UP STATE menu.
VIDEO
D. AUDIO

∑ Checking the input signals

≥To monitor the input signals during recording:
(1) Connect a TV monitor to the serial monitor connector.
Connect the audio monitor connector to the monitor speaker.
(2) Press the INPUT CHECK button.
INPUT CHECK
≥STATE menu:
How to display the
menus:
≥or
REC
TAPE
≥The digital audio and the digital video signals are interlinked at
REC
TAPE all times. They can not be set separately.
≥Simultaneous playback of the analog cue signal is not possible.
TAPE
≥Simultaneous playback monitoring is not possible when the F1
(OUTPUT) key on the HOME menu is set to EE.
≥Even when the state menu setting is EE1 or EE2, simultaneous
playback monitoring of both the video and audio signals is pos-
sible by setting the F1 (OUTPUT) key on the HOME menu to
TAPE.
While this button is held down, the video signal can be checked
using the serial monitor output connector.
≥Only the audio signal selected by the L and R buttons can be
monitored (via the audio monitor connector or the headphone
connector).
* In the HD mode, only the HD-SDI monitor output can be
switched to the input signals; in the SD mode, only the
SD-SDI monitor output and VIDEO3 output can be
switched to the input signals.
# #
VIDEO OUT F8 F12
# # F12
AUDIO OUT F8
≥HOME menu:
HOME
– 24 –