HP 6033A series Service Manual page 100

On Page 17, in Voltage Monitor and Remote Readback Full Scale Calibration step c,
change 5.000625V to 4.250625V ±100µV (6033A).
change 5.000625V to 4.168125V ±80µV (6038A).
On Page 17, in Voltage Monitor and Remote Readback Full Scale Calibration step f,
change 20V and 20.005V to 17.000 and 17.005V (6033A).
change 60V and 60.015V to 50.025V and 50.01V (6038A).
On Page 19, in Power Limit Calibration step d, change 10A to 9.2A (6033A)
On Page 19, in Power Limit Calibration step e,
change ISET 30.5 to ISET 27.5 (6033A).
change VSET 23 to VSET 21 (6038A).
On Page 21 in Voltage Programming and Readback Accuracy step g,
change VSET 20 to VSET17 (6033A).
change VSET 60 to VSET 50 (6038A).
On Page 22, in Voltage Programming and Readback Accuracy step h,
change 19.984 and 20.016 to 16.988 and 17.012 (6033A).
change 59.939 and 60.061 to 49.9375 and 50.0525 (6038A).
On Page 22 in Voltage Programming and Readback Accuracy step I,
change 0.02 to 0.018V (6033A).
On Page 22, in Load Effect (Load Regulation) step c,
change 7.0V to 6.25V (6033A).
change 20.0V to 15.0V (6038A).
On Page 22 in Load Effect (Load Regulation) step d,
change 29A to 25A (6033A).
On Page 22 in Load Effect (Load Regulation) step h,
change 0.0027V to 0.0026V (6033A).
On Page 23, in Source Effect (Line Regulation) step d,
change 20V to 17V (6033A).
change 60V to 50V (6038A).
On Page 23, in Source Effect (Line Regulation) step e,
change 10A to 9A (6033A).
On Page 23, in Source Effect (Line Regulation) step i,
change 0.003 to 0.0027 (6033A).
change 0.08 to 0.007 (6038A).
'
On Pages 23, 25, in RMS Measurement Procedure and Peak Measurement step c,
change 7.0 to 6.25V (6033A).
On Pages 23, 25, in RMS Measurement Procedure and Peak Measurement step d,
change 29A to 25A (6033A).
On Page 25, in Load Transient Recovery Time and step c
change 6.7V to 5.0V (6033A).
100