Using The Mc Protector/Pl Filter - Panasonic Lumix DMC-L10K Operating Instructions Manual

• If you use commercially available external
flashes with communication functions
other than the dedicated one, they may
not operate normally or they may be
damaged. Do not use them.
• Even if the external flash is turned off,
the camera may enter the external flash
mode when the external flash is
attached. When you are not using the
external flash, detach it.
• When attaching the external flash, the
built-in flash cannot be activated.
• Do not open the built-in flash when an
external flash is attached.
• When attaching the external flash, the
camera will become unstable.
• Detach the external flash when carrying
the camera.
• When attaching the external flash, do not
hold only the external flash because it
may detach from the camera.
• If you use the external flash when the
white balance is set to [
adjust the white balance depending on the
picture quality. (P74)
• If you take pictures close to the subject in
Wide, the vignetting effect may appear on
the bottom of the recorded picture.
• Read the operating instructions of the
external flash for details.
Using the MC
Protector/PL Filter
The MC protector is a transparent filter
which affects neither the colors nor the
amount of light, so it can always be used to
protect the camera's lens. Also, the PL filter
reduces diffused light reflection so you can
take pictures with increased contrast.
1 Detach the lens cap.
] (Flash) finely
2 Attach the MC protector A or the
PL filter B.
A
• You cannot attach the MC protector and
the PL filter at the same time.
• If the MC protector/PL filter are tightened
too much, you may not be able to remove
them. Do not tighten them too much.
Others
B
123
VQT1G46