2.2.10 IDE Secondary Channel Slave
This parameter specifies the current configuration of the IDE device connected to the
slave port of the secondary IDE channel. For information on how to configure the IDE
drives, see section 2.3.4.
2.2.11 Total Memory
This parameter specifies the total amount of onboard memory.
The memory size is
automatically detected by BIOS during the POST. If you install additional memory, the
system automatically adjusts this parameter to display the new memory size.
1st Bank/2nd Bank
The 1st Bank and 2nd Bank parameters indicate the type of DRAM installed in DIMM
sockets 1 and 2 respectively.
None
setting indicates there is no DRAM installed. For the
location of the DIMM sockets, refer to Figure 1-1.
2.2.12 Serial Port 1
This parameter shows the serial port 1 address and IRQ settings.
2.2.13 Serial Port 2
This parameter shows the serial port 2 address and IRQ settings.
2.2.14 Parallel Port
This parameter shows the parallel port address and IRQ settings.
Index