Starting Operation - Hsi Electronic Ignition Lighting/Operation; Operating Instructions; To Turn Off Gas To Appliance - Pentair Pool Products MiniMax NT Series Service Manual

Starting Operation (HSI)
FOR YOUR SAFETY: READ BEFORE LIGHTING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal
injury or loss of life.
Do not attempt to light the heater if you suspect a natural gas leak. Lighting the heater can result in a fire or
explosion which can cause personal injury, death, and property damage.
A. This appliance does not have a pilot. It is
equipped with an ignition device which
automatically lights the burners. Do not try to
light the burners by hand.
B. BEFORE OPERATING, smell all around
the appliance area for gas. Be sure to smell
next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance.
- Do not touch any electrical switch; do not use
any phone in your building.
- Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
1. STOP! Read the safety information above.
2. Turn off electric power to the heater.
3. Set the thermostat to the lowest setting.
4. This appliance is equipped with an ignition
device which automatically lights the burners.
Do not try to light the burners by hand.
5. Remove the control access door.
6. Push in gas control knob slightly and turn
clockwise
NOTE: Knob cannot be turned to "OFF" unless
knob is pushed in slightly. Do not force.
7. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow "B" in the safety
information above. If you don't smell gas, go to
the next step.
1. Turn off all electric power to the appliance if
service is to be performed.
2. Set the thermostat to lowest setting.
3. Remove control access door.
Rev. B 2-11-04

OPERATING INSTRUCTIONS

to "OFF".

TO TURN OFF GAS TO APPLIANCE

HSI ELECTRONIC IGNITION
WARNING
- If you cannot reach your gas supplier, call the
Fire Department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair it,
call a qualified service technician. Forced or
attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
8. Turn gas control knob counterclockwise
to "ON". See Figure 20.
9. Replace the control access door.
10. Set the thermostat to the desired setting.
11. Turn on the electrical power to the appliance.
12. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance"
and call your service technician or gas supplier.
Gas
Inlet
Gas control knob shown in "ON" position.
Figure 20.
4. Push in gas control knob slightly and turn
clockwise
5. Replace control access door.
LIGHTING/OPERATION
ON
OFF
to "OFF". Do not force.
23
P/N NTSM03