Epson SC-P9000 Series User Manual page 117

SC-P9000 Series/SC-P7000 Series/SC-P8000 Series/SC-P6000 Series User's Guide
Item
Auto Cut
Page Line
Roll Paper Margin
Refresh Margin
Roll End Option
Roll Paper Tension
Custom Paper Setting
Set each item in the following table for commercially available paper based on the characteristics of the paper. When
customizing paper settings for genuine Epson paper, select the corresponding paper type from Select Reference
Paper, and then enter your settings.
* Default setting
Using the Control Panel Menu
Description
*
Choose On to automatically cut roll paper using the built-in cutter as each
On
page is printed or Off to disable auto paper cutting. The setting selected
with the printer driver takes priority when the printer driver is used.
Off
* If Auto Cut is Off, you can choose to print (On) or not print (Off) cut lines on
On
roll paper. Cut lines are not printed if Auto Cut is On or when cut sheets or
poster board is used.
Off
Note, however, that if the roll width selected with the computer is
narrower than the paper loaded in the printer, cut lines will be printed
regardless of the option selected for Auto Cut.
The setting selected with the printer driver takes priority when the printer
driver is used.
*
When set to Normal, the top and bottom margins are 15 mm, and the left
Normal
and right margins are 3 mm.
Top15mm/
Except for 15mm, the left and right margins for all other settings are 3
Bottom15mm
mm.
"Printable area" on page 52
Top35mm/
U
Bottom15mm
Top150mm/
Bottom15mm
3mm
15mm
* If On is selected during borderless printing, the printer will automatically
On
trim the leading edge to remove any ink stains that may have been left by
the previous copy; to disable this feature, choose Off.
Off
Continue Select the action to perform for a roll after replacement: print the
remaining data (Continue) / do not print (Stop Printing) / print again
*
from the beginning (Reprint).
Stop Printing
Reprint is only available when the optional hard disk unit is installed.
Reprint
*
This setting is used if Extra High is set as one of the following settings:
1 to 5 (3 )
Paper menu - Custom Paper Setting - Roll Paper Tension, or Paper
Configuration - Roll Paper Back Tension in the printer driver.
If wrinkles are formed on the paper during printing when the
abovementioned Roll Paper Back Tension is High, set it to Extra High,
and then configure the strength of the tension using this setting.
Higher values produce higher tension.
117