Canon imageRUNNER Advance 4251 Basic Operation Gude page 64

• Paper which is curled must be straightened out before loading it into the paper deck unit.
• You will not be able to make copies or print if you load paper that exceeds the loading limit mark (
is not completely pushed into the machine.
• Make sure that the height of the paper stack does not exceed the loading limit mark (
• Always check that the paper drawers are in place.
• When loading paper into the paper drawer for the fi rst time, set the paper size dial to match the paper size being loaded. (See
"Adjusting a Paper Drawer to Hold a Diff erent Paper Size, " on p. 65.)
• The number of sheets that can be loaded in the paper drawers is 550 sheets (21 lb bond (80 g/m
• If there are instructions on the paper package about which side of the paper to load, follow those instructions.
• When the paper is loaded into the paper drawer, the side facing up is the one printed on.
• If problems, such as poor print quality or paper jams occur, try turning the paper stack over and reloading it.
• For more information on the print direction of preprinted paper (paper which has logos or patterns already printed on it), see
e-Manual > Copy.
• Rewrap any remaining paper in its original package, and store it in a dry place, away from direct sunlight.
• If paper runs out and printing is stopped, load a new paper stack. Printing restarts after the new paper stack is loaded.
• If you print on the paper which has absorbed moisture, steam may come out from the output area of the machine. This is
because the moist on the paper evaporates when the high temperature is applied when a toner is fi xed to the paper. It is not a
malfunction. (This especially happens in low room temperature.)
64
), or if the paper drawer
).
2 )).