Advertisement
USE CHARGERS ONLY WITH BATTERY PACKS AND ITEM NUMBERS LISTED BELOW:
NOTE: The item number of the product containing each battery pack is shown in parenthesis.
CHARGER
11053
130139017 (11534), 1322519 (11332), 1322549 (11452), 1323412 (11347), 1322550 (17753)
11055
130139014 (11535 / 11536), 130139014 (11565), 1310714 (11413), 1322518 (11414), 1323407 (11333),
11006
1323407 (11409), 1310714 (11422), 130234026 (11460), 1323407 (177550), 1323407 (11400)
11466
11369
130260001 (11537), 130260001 (11524), 130139021 (11385), 130139020 (11386), 130260001 (113861),
11379
CHARGING THE BATTERY PACK
Charge battery pack only with the charging assembly
provided.
Make sure power supply is normal household voltage,
120 volts, 60 Hz, AC only.
Connect charger to power supply.
Place battery pack in charging stand. Align raised rib
on battery pack with groove in charging stand. See
Figure 2.
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
stand.
The charge indicator light (LED), located on the
charging stand, will light up red and glow when the
charger is properly connected to power supply. This
light indicates the charger is operating properly. It will
remain on until battery pack is removed from charging
stand or charger is disconnected from power supply.
After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack.
NOTE: If both red and orange LED indicators glow, the
battery pack is deeply or completely discharged, and
6 hours or longer of charging time is required to fully
recharge the battery pack.
If the charger does not charge the battery pack, or
the orange LED continues to glow after more than
30 minutes of charging, the battery pack may be
defective. Return the battery pack and charging
assembly to your nearest Sears Repair Center for
electrical check.
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
OPERATION
COMPATIBLE BATTERY PACKS
130139016 (11533), 1323405 (11331), 1323424 (11451)
Note: Battery sold as Item No. 11054
Note: Battery sold as Item No. 11057
Note: Battery sold as Item No. 11007
130139015 (11521), 130234027(11463)
Note: Battery sold as Item No. 11465
1323414 (11415 / 11410)
Note: Battery sold as Item No. 11368
130260001 (114232), 1323509 (11416), 1323520 (11461)
Note: Battery sold as Item No. 11378
When batteries become fully charged, unplug charger
CHARGING A HOT BATTERY PACK
When using your tool continuously, the batteries in your
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge.
NOTE: This situation only occurs when continuous use of
your tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to Charging
the Battery Pack for normal recharging of batteries. If
the charging assembly does not charge your battery pack
under normal circumstances, return both the battery pack
and charging assembly to your nearest Sears Repair
Center for electrical check.
4
from power supply and remove the battery pack.
BATTERY PACK
SHOWN IN CHARGER
REd LEd
ORANGE LEd
CHARGING
ASSEMBLY
CHARGING STANd
Fig. 2
Advertisement
