GE GXSF30V Owner's Manual & Installation Instructions page 25

Before you call for service.
Problem
Excessive/high level
of water in brine
tank
Salty tasting or
brown/yellow
colored water after
installation
Brown/yellow
colored water
Resin beads show-
ing up in drinking
water
Sounds you might
hear
Water has air bub-
bles and is cloudy
Blue light Flashing
When power applied
to the system
If "DAYS TO EMPTY"
is flashing
Possible Cause
Valve drain hose pinched, plugged,
elevated too high or otherwise
restricted
Drain lines connected together
Nozzle and venturi dirty, incorrectly
assembled or damaged.
Unit not sanitized
Low water pressure
Restricted drain hose
Unit was idle for a period of time
Cracked distributor or unit plumbed
backwards
Running water from the unit into a
drain during recharge
Air in system after installation
Control needs to be programmed (a
power outage may have occurred)
Low salt level, less than 15 days
What to do
operation of the nozzle and venturi and reduce or
prevent brine draw during recharge.
instructions. With water pressure to the water
softening system off, take the nozzle assembly
apart. Inspect, clean and replace as needed.
Any foreign particle(s), scratches, nicks, etc. in the
passages can prevent operation. Be sure holes in
the gasket are centred over holes in the housing
run water from faucets to purge the salty water.
Check pressure:
mum 20 psi.
mum 50 psi.
25
-
-