Power Computing ATARI PC720 Owner's Manual page 14

Blitz on the PC880B
Running the Blitz! Amiga Program
Switch off your Amiga. and move the function switch on the PC880B to
the position marked "B". Switch on your Amiga and insert the Blitz!
Amiga disk once the workbench prompt appears. After a short time, the
Blitz! main screen will appear. Wait until your internal drive access light
goes out before removing the Blitz! Amiga software disk.
Using the Blitz! Amiga Program
Simply insert the disk that you wish to copy into your DFO: (or boot)
floppy drive, and blank disks that you wish to copy to into ALL external
floppy drives. Please note that the disk in DFO: must be write protected,
and those in the other drives must not.
Press the left mouse button with the mouse pointer somewhere in the
centre of the screen, and the copy process will begin. If you wish to abort
the copy operation. simply hold down the left mouse button for a
few seconds.
More Complex Copy Operations
Normally, none of the Blitz! Amiga settings will have to be altered, even
ifthe disk that you wish to copy is for a n STor PC for example. However.
if you d o wish to copy a PC or ST disk, the copy will take less time if you
tell Blitz! Amiga that it is a PC or ST disk. To d o this, press and hold the
right mouse button, move the mouse pointer over the 'Mode' menu item
at the top of the screen, and select the appropriate format. The 'Options'
menu allows you to copy only part of a disk, or to quit the program.
Notes When Using Blitz! Amiga
1. We strongly advise against copying onto unbranded disks.
2. Blitz! has no way of telling if the copy was successful, and so it may
occasionally be necessary to re-copy a disk that has failed. Always
check the disks that you have copied.