Related Manuals for M&K Sound MPS-2810
Summary of Contents for M&K Sound MPS-2810
- Page 1 Powered Subwoofer Operation Manual MPS-5410 MPS-2810 MPS-5310 ©2004 M&K Sound, Inc.
-
Page 2: Safety Instructions
11. SERVICING - Do not attempt to service this product yourself. Opening or removing covers, including any over bottom or side speaker drivers, may expose you to dangerous voltage or other hazards. Refer all service to qualified service personnel. 12. DAMAGE REQUIRING SERVICE - Unplug this product from the wall outlet and refer servicing to qualified personnel under the following conditions: •... -
Page 3: Table Of Contents
THE LOGIC BEHIND BASS MANAGEMENT...5 QUICK PRODUCT OVERVIEW...6 SUBWOOFER PLACEMENT...6 INPUTS AND CONTROLS...8 RESPONSE AND SENSITIVITY ADJUSTMENTS...9 CALIBRATING YOUR M&K PROFESSIONAL SYSTEM ...9 SPEAKER CALIBRATION...10 SUBWOOFER CALIBRATION...11 THE FOUR MAJOR ADVANTAGES OF USING BASS MANAGEMENT...11 SPECIFICATIONS...12 INPUTS AND CONTROLS...8 CABINET DIMENSIONS...12-14... -
Page 4: Introduction
INTRODUCTION Congratulations and thank you for purchasing this M&K powered subwoofer. Miller & Kreisel Professional powered subwoofers are designed to provide many years of accurate and problem free operation. We strongly encourage you to read this owner's manual, as there is a great deal of information provided here to help you get the best possible performance from your new M&K Professional subwoofer. -
Page 5: M&K's Design Philosophy
As an audiophile recording engineer and a high-end loudspeaker designer, my strong belief has always been that a good loud- speaker should accurately and realistically reproduce whatever the microphone captured, whether the source is a human voice, a musical instrument, an explosion, car crash, etc; including the acoustical ambiance of the environment in which the source was recorded. -
Page 6: Quick Product Overview
SPL meter. QUICK PRODUCT OVERVIEW The MPS-2810 provides low-frequency extension in the smallest practical size. With 200 watts of power and M&K’s Push- Pull™ Technology. The MPS-2810 provides a powerful, compact, uncompromised solution where space is at a premium. The MPS-5310 is a 350-Watt powered subwoofer that is certified for THX pm3 applications with reference level output in rooms up to approximately 3000 Cubic Feet in volume (multiple subs can be used for larger room applications). - Page 7 The cabinet's 17" width allows the MPS-2810 to be rack mounted for professional applications or installations where space is at a premium. If you want to do this, contact M&K for a rack-mounting kit.
-
Page 8: Inputs And Controls
INPUTS AND CONTROLS (MPS-5310 SHOWN AND SHOULD BE USED FOR REFERENCE ONLY, CONTROLS MAY NOT APPLY TO ALL MODELS) A) Mono Balanced Input - 61K Ohms balanced input connector - 200mv in produces 90dB of output (Reference/THX input sensitivity mode). Pin Polarity: 1. -
Page 9: Response And Sensitivity Adjustments
The MPS-5310 features an adjustable 36dB per octave, variable low-pass filter. This filter can be useful when using this sub- woofer with non M&K Professional monitors so as to help provide a perfect match at crossover between the main speaker(s) and the subwoofer. -
Page 10: Speaker Calibration
45 degree angle to vertical and at arm’s length to avoid a false reading from sound bouncing off your body and into the microphone. Point the meter at the center speaker at about ear height. Play track one of the test CD through the selected speaker and read the... -
Page 11: Subwoofer Calibration
Set your SPL meter for C weighting and slow response. Set the scale to 80dB. Point the meter at the center speaker at ear height with the meter at a slightly up-turned angle. Play track two of the test CD through the selected speaker and read the SPL (Remember that the LFE-4 will re-route all frequencies below 80 Hz to the subwoofer.) Adjust the subwoofer level using a small... -
Page 12: Specifications
SPECIFICATIONS MPS 5410 (THX PM3 APPROVED) DRIVER COMPLEMENT CABINET TYPE RATED POWER OUTPUT PEAK POWER OUTPUT (20 millisecond pulse) AMPLIFIER DISTORTION AMPLIFIER NOISE (relative to full output) TYPICAL ROOM RESPONSE ANECHOIC RESPONSE INPUT IMPEDANCE BALANCED UNBALANCED LOW PASS FILTER fixed variable 2 X 12”... - Page 13 MPS 5310 (THX PM3 APPROVED) DRIVER COMPLEMENT CABINET TYPE RATED POWER OUTPUT PEAK POWER OUTPUT (20 millisecond pulse) AMPLIFIER DISTORTION AMPLIFIER NOISE (relative to full output) TYPICAL ROOM RESPONSE ANECHOIC RESPONSE INPUT IMPEDANCE BALANCED UNBALANCED LOW PASS FILTER fixed variable 2 X 12”...
- Page 14 22 HZ – 125 HZ +/- 2 db (ANECHOIC POSITION) 15K OHMS 15K OHMS 80Hz / 24db PER OCTAVE SLOPE (4th order Linkwitz-Riley) 55Hz - 125Hz 17.50 14.50 14.88 10.00 MPS-2810 5.50 3.13 2.13 2.21 5.50 MPS Sub Manual.qrk 3/23/2004...