Amana AMVM97 Service Instructions Manual page 7

PRODUCT IDENTIFICATION
MODEL # MFG #
AFE18-60A
N/A
P1251305F
AMU1620
P1251306F
AMU1625
P1251307F
AMU2020
P1251308F
AMU2025
GMU1620
GMU1625
N/A
GMU2020
GMU2025
ASAS-10
P1251301F
ASAS-11
P1251302F
P1251303F
ASAS-12
P1251304F
ASAS-18
CFSB17
CFSB21 N/A
CFSB24
CTK01
CTK01AA
CTK01BA
CTK01BA
CTK02**
CTK02**
CTK03A* CTK03A*
CTK04A*
CTK04A*
Fossil Fuel Kit. The AFE18-60A control is designed for use where the indoor coil is located above/downstream
of a gas or fossil fuel furnace when used with a heat pump. It will operate with single and two stage heat
pumps and single and two stage furnaces. The AFE18-60A control will turn the heat pump unit off when the
furnace is turned on. An anti-short cycle feature initiates a 3 minute timed off delay when the compressor goes
off.
Media Air Cleaner. For use with current architectural grey Goodman® and Amana® Brand 96% variable speed,
modulating furnace models. The Amana (AMU*) and Goodman (GMU*) Media Air Cleaner is a high efficiency
air filtration device designed to remove dirt, dust, pollen and other microscopic particles from the air passing
through it. Flexible performance range up to 2,000 CFM capacity. The air cleaner should be installed in the
system so that all the system air is circulated through the air cleaner. The air cleaner will only remove the
airborne contaminants delivered to it. Maximum performance is obtained when the system blower is set for
continuous operation. Carbon filters (optional) are available.
Electronic Air Cleaner. For use with current architectural grey Goodman® and Amana® Brand 96% variable
speed, modulating furnace models. The High-Efficiency Electronic Air Cleaner is designed to remove air
contaminants down to .01 microns. Carbon filters (optional) remove odors. Dual indicator lights show unit
operation at a glance. Electronic proving switch cycles the air cleaner On/Off with the system fan. Durable
powder-coat paint finish resists corrosion.
Counterflow Subbase Kit. For use with Goodman®, & Amana® Brand modulating 34.5" furnace models.
These kits are available for the following furnace widths: 17.5" wide (CFSB17), 21" wide (CFSB21) and 24"
wide (CFSB24). The kits must be used to prevent excessive temperature from reaching combustible materials,
if the furnace is installed on a combustible floor. This subbase effectively separated the furnace base and
plenum from combustible materials. To ensure safe installation, do not install the counterflow floor base
directly on carpeting, tile, or other combustible material other than wood flooring.
Communicating Thermostat Kit- Digitally communicating touchscreen thermostat, a necessary part of any
communicating system. Designed for use with compatible Amana® Brand or Goodman® Brand Air Handlers
or Furnaces and outdoor split AC or Heat Pump units. This thermostat supports up to three stages of heat, two
stages of cooling, dual fuel applications, dehumidification, filter maintenance reminders, outdoor temperature
display and advanced menus including diagnostics. The CTK01AA kit includes a communicating touchscreen
thermostat and sub base, 230V-24V 40va transformer, terminal blocks(2), wire jumpers,
mounting screws, installation manual and homeowner guide.
Communicating Thermostat Kit- Digitally communicating touchscreen thermostat, a necessary part of any
communicating system. Designed for use with compatible Amana® Brand or Goodman® Brand Air Handlers
or Furnaces and outdoor split AC or Heat Pump units. This thermostat supports up to three stages of heat, two
stages of cooling, dual fuel applications, dehumidification, filter maintenance reminders, outdoor temperature
display and advanced menus including diagnostics. The CTK01BA kit includes a communicating touchscreen
thermostat and sub base, terminal blocks(2), mounting screws, installation manual and homeowner guide.
Communicating Thermostat Kit- Digitally communicating thermostat, a necessary part of any communicating
system. Designed for use with compatible Amana® Brand or Goodman® Brand Air Handlers or Furnaces and
outdoor split AC or Heat Pump units. The CTK02** thermostat features full color, high definition display,
advanced programming options including humidification control & heat and cool maximum temperature
settings, a USB plug allowing dealers the ability to insert pre-programmed operating parameters and dealer
information by use of an online data entry system.
Communicating Thermostat Kit- Digitally communicating touchscreen thermostat from Honeywell. Designed
for use with compatible Amana® Brand or Goodman® Brand Air Handlers or Furnaces and outdoor split AC or
Heat Pump units. The CTK03A* thermostat features full color high definition display, can be used with
RedLINK wireless accessories.
Communicating Thermostat Kit- Digitally communicating touchscreen thermostat from Honeywell. Designed
for use with compatible Amana® Brand or Goodman® Brand Air Handlers or Furnaces and outdoor split AC or
Heat Pump units. The CTK04A* thermostat features full color high definition display, can be used with
RedLINK wireless accessories. Split system inverter capable.
DESCRIPTION
7