Table of Contents
Advertisement
◆
Place the leads in the lead guides.
Closing the battery cover
Place the cover on the battery compartment as
shown in the diagram, then push it up until it clicks
into position.
Opening the battery cover
Press down on the battery cover below its upper
end and slide the cover down.
Step 3: Registering the handset to
the base station and charging the
battery pack
Precondition: The handset must not already be
registered to a base station.
The handset is automatically registered to the
Gigaset A140/AL145 base station. Place the hand-
set in the charging cradle of the base station with
its display facing forward. You will hear a confir-
mation tone. Leave the handset in the base station
until it is registered.
Automatic registration can take up to 5 minutes.
While this is happening, Registering flashes in the
screen. The handset is assigned the lowest unas-
signed internal number (1–4). If several handsets
are registered on the base station, the internal
number is shown in the top left of the display after
registration, e.g. 2. If the internal numbers 1 to 4
have already been assigned (four handsets have
3
already been registered), handset number four is
deregistered and overwritten.
Please note:
If you have acquired additional handsets in this
Gigaset family or other Gigaset handsets, each
handset must be registered to your base station in
order for them to work properly, see also page 7!
Charging the battery pack
To charge the battery pack, leave the handset in
the base station for approx. 7 hours. The battery
pack is now fully charged. The charge status of the
battery pack is only correctly displayed after unin-
terrupted charging/discharging. Therefore you
should not interrupt the charging process.
Charging is electronically controlled to prevent
overcharging. The battery pack heats up during
charging. This is normal and not dangerous. After
a time its charge capacity will decrease for techni-
cal reasons.
You must set the date and time to ensure that the
times of calls are logged correctly (see Menu tree
page 11).
Once the phone is registered and the time set, the
idle display looks as shown on page 1.
If you have any questions about using your phone,
please read the tips on troubleshooting ("Ques-
tions and answers", page 9) or contact our cus-
tomer service department (page 10).
Making calls
Making external calls and ending calls
External calls are calls using the public telephone
network.
~
(Enter the phone number)
The number is dialled. (Or you can first press and
c
hold
[dial tone] and then enter the number.)
During the call you can adjust the earpiece volume
t
using
.
End the call/cancel dialling:
Press the end call key
You can automatically insert a network provider
dialling code before any phone number (see
"Preselection" Menu tree, page 11).
Accepting a call
The handset indicates an incoming call by ringing
and by a display on the screen.
c
Press the talk key
When Auto Answer is activated (see Menu tree,
page 11), simply remove the handset from the
base station/charging cradle.
¢
c
.
a
.
to answer the call.
Hide quick links:
Advertisement
Table of Contents
