Renault Kadjar Driver's Handbook Manual page 114

STOP AND START FUNCTION
Conditions preventing the
standby of the engine
Certain conditions prevent the system
from using the engine standby function,
including when:
– reverse gear is engaged;
– the bonnet is not locked;
– the driver's door is not closed;
– the driver's seatbelt is not fastened;
– the outdoor temperature is too low or
too high (less than around 0 °C or
higher than around 30 °C);
– the battery is not sufficiently charged;
– if available, "4WD Lock" mode is
activated (please see the section
"Transmission: 4-wheel drive (4WD)"
in Section 2);
– the difference between the vehicle
interior temperature and the auto-
matic climate control instruction is
too high;
2.10
(3/4)
– parking distance control is in opera-
tion;
– for vehicles with automatic gear-
boxes, the gradient is steeper than
approximately 12%;
– the "Clear View" function is activated
(please see "Automatic Climate
Control" in Section 3);
– the engine temperature is too low;
– the emission control system is being
regenerated;
or
– ...
Warning light is displayed on the
instrument panel. This notifies you that
engine standby is not available.
Deactivate the Stop and
Start function when per-
forming any operations in
the engine compartment.
Special cases for vehicles
with a RENAULT card
With the engine on standby (traffic jam,
traffic lights, etc.), if the driver unfas-
tens the seat belt and opens the driv-
er's door, or gets out of the seat, the
ignition is switched off.
The assisted parking brake is applied
automatically.
To restart and reactivate the Stop and
Start system, start the engine (please
refer to "Starting, stopping the engine"
in Section 2).