Mitsubishi Electric XD211U Information Sheet

TM
DLP Projector
XD211U/XD210U/SD210U
Controlling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions :
• Turning the power ON or OFF
• Changing input signals
• Volume, Keystone, Mute, Remote, Reading commands
Connection
Important:
• Make sure that your computer and projector are turned off before connection.
• Boot up the computer first, and then plug the power cord of the projector.
(If you do not follow this instruction, the Comport may not function.)
• RS232C cables may be necessary when you control the projector. Contact your dealer for details.
1) Interface
PROTOCOL
BAUD RATE
DATA LENGTH
PARITY BIT
STOP BIT
FLOW CONTROL
This projector uses RXD, TXD and GND lines for RS-232C control.
For RS-232C cable,the reverse type cable should be used.
2) Control command diagram
The command consists of the address code, function code, data code, and end code. The length of the command
varies among the functions.
Address code
HEX 30h 30h
ASCII '0' '0'
[Address code] 30h 30h (In ASCII code, '0' '0') fixed.
[Function code] A code of each fixed control move.
[Data code] A code of each fixed control data (number) and not always indicated.
[End code] 0Dh (In ASCII code, '
RS-232C
9600 [bps]
8 [bits]
NONE
1 [bit]
NONE
Function code
Function
Function
') fixed.
DIN 8-pin
Data code End code
Data
Data
1
SERIAL
COMPUTER IN
0Dh