Table of Contents
Advertisement
Troubleshooting
The following offers solutions to some of the common problems you may encounter. We suggest that you consult this chart before contacting your
dealer.
Images aren't projected on the screen.
Problem
Power isn't turned on.
Images aren't projected on the screen.
Images suddenly disappear.
"NO SIGNAL" is displayed.
•
Check the states of the indicators.
POWER
STATUS
Solution
Connect the power cord to the projector.
Off
Off
Plug the power cord into a wall outlet.
If any objects are blocking the air inlet or outlet grille, remove them and carry out
the following.
1.
Unplug the power cord from the wall outlet.
Off
2.
Make sure that the projector has cooled off.
3. Plug the power cor d into the wall outlet.
4. Press the POWER button.
If any objects are blocking the air inlet or outlet grille, remove them.
Don't expose the air outlet grilles to hot air emitted from a heating appliance.
Steady red
Blinking
orange
After the STATUS indicator stops blinking, press the POWER button.
If you unplug the power cord while the fan is rotating, the lamp may not turn on about
Blinking
one minute when you plug the power cord next time.
green
The lamp can't turn on again for one minute after it goes out.
Press the POWER button several times.
Replace the lamp. (The lamp is at the end of its life.)
Steady red
Attach the lamp cover on the bottom.
Off
Blinking red
Unplug the power cord from the wall outlet and contact your dealer.
/ green
Steady
or
Blinking
•
Cancel the AV mute by pressing the MUTE button.
•
Remove the lens cap.
•
The lamp sometimes takes about one minute to light up.
•
On rare occasion, the lamp fails to light up. In such cases, wait a few minutes and try to light the lamp again.
•
If the projector was turned off before the lamp cooled down completely, the fans may start rotating and the
POWER button may not function when you plug the power cord into the wall outlet next time. Wait for the fans
to stop and press the POWER button to turn on the lamp again.
•
Check that the lamp cover are closed.
•
Check that the cable connected to the external device isn't broken.
•
When an extension cord is being used, replace it with the supplied cable and check whether images are pro-
jected correctly. If images are projected correctly, use an RGB signal amplifier along with the extension cord.
•
The air inlet or outlet grille may be blocked. (In such cases, the STATUS indicator blinks orange.)
Remove the objects blocking the air inlet or outlet grille and carry out the following.
1.
Wait for the air inlet or outlet fan to stop (or wait for the STATUS indicator to go out.)
2.
Unplug the power cord from the wall outlet.
3.
Wait about 10 minutes.
4.
Plug the power cord into the wall outlet.
5.
Press the POWER button.
•
When the STATUS indicator is blinking red, it is indicating that the lamp should be replaced. Replace the lamp
in this case.
•
Turn on the power of the connected device, or check whether there is something wrong with the connected
device.
•
Check whether the external device outputs signals. (Check this especially when the external device is a note-
book computer.)
•
Check that the cable connected to the external device isn't defective.
•
Check that the projector is connected to the external device using the correct terminals.
•
Check that the connected device is correctly selected as the input source.
•
When an extension cord is being used, replace it with the supplied cable and check whether images are pro-
jected correctly. If images are projected correctly, use an RGB signal amplifier along with the extension cord.
Cause and solution
EN-23
Hide quick links:
Advertisement
Table of Contents
