Craftsman 315.212400 Owner's Manual page 20

CUTTING WARPED MATERIAL
See Figures 23 and 24.
RIGHT
When cutting warped material, always make sure it is
positioned on the miter table with the convex side
against the fence as shown in figure 23.
If the warped material is positioned the wrong way as
shown in figure 24, it will pinch the blade near the
completion of the cut.
WARNING: To avoid a kickback and to avoid
serious personal injury, never position the
concave edge of bowed or warped material
against the fence.
WRONG
OPERATION
0
Fig. 23
0
Fig. 24
CLAMPING WIDE WORKPIECES
See Figure 25.
When cutting wide workpieces such as a 2 in. x 6 in.,
boards should be clamped with a C-clamp as shown in
figure 25.
20
WIDE
BOARD
Fig. 25