Basic Operation - Mitsubishi Electric EX100U User Manual

Basic operation

4
6
3, 1, 2
Power-on
1. Turn on the device connected to the projector fi rst.
2. Plug the power cord in the wall outlet.
• The POWER indicator lights up.
• If the power cord is unplugged from the wall
outlet before the projector is cooled down com-
pletely after use, the fans may start rotating when
the power cord is plugged in next time and the
POWER button may not function. In this case,
wait for the fans to stop and press the POWER
button to light the indicator.
3. Press the POWER button on the control panel or the
ON button on the remote control.
• It may take about one minute for the lamp to light
up.
• The lamp occasionally fails to light up. Wait a few
minutes and try to light the lamp again.
• After the POWER button is pressed, the image
may fl icker before the lamp becomes stable. This
is not a product malfunction.
For EX100U
• Regardless of the setting of LAMP MODE in the
INSTALLATION menu, the STANDARD lamp mode
is activated by default whenever the projector is
turned on. When LAMP MODE has been set to
LOW, the lamp mode changes from STANDARD
to LOW about one minute after turn-on.
For ES100U
• You can't change the lamp mode for one minute
after turning on the projector.
Condition
Stand-by
When the lamp is on.
Important:
• Do not cover the lens with the lens cap while the
lamp is on. Do not strip off the aluminum sheet in-
side the lens cap.
POWER
5
Indicator
STATUS
POWER
-
Red
Green Green
3
STATUS
5
• The projector starts warming up when the POWER
button is pressed. During the warm-up process,
images may appear dark and no commands are ac-
cepted.
• By blinking red, the STATUS indicator indicates that
the lamp should be replaced soon. Replace the lamp
when the STATUS indicator blinks red. (See page 23
and 26.)
• Images may not be projected with good quality in
an extremely hot or cold environment. (This is not a
product malfunction.)
4. Adjust the focus by turning the focus ring.
5. Choose your desired external input source using the
COMPUTER or VIDEO button.
• The input source is switched between COM-
PUTER 1 and COMPUTER 2 at every press of the
COMPUTER button on the control panel.
• The input source is switched between VIDEO(1)
and S-VIDEO(2) at every press of the VIDEO but-
ton on the control panel.
• The projector automatically selects the appropri-
ate signal format. The selected signal format is
displayed on the screen.
• The COMPUTER and VIDEO buttons don't func-
tion while the menu is being displayed.
• When COMPUTER 1 or COMPUTER 2 is chosen
as the source, images supplied from the compu-
ter may fl icker. Press the
remote control to reduce fl icker, if it occurs.
• To avoid permanently imprinting a fi xed image
onto your projector, please do not display the
same stationary images for long period.
6. Adjust the image size by turning the zoom ring.
• If necessary, adjust the focus and zoom again.
ON POWER OFF
1, 2
STILL MUTE UP
PAGE
AUTO POSITION
DOWN
ENTER
MENU 16:9
COMPUTER
1 2
5
VIDEO
1 2
KEYSTONE VOLUME
or button on the
EN - 13