[Network Settings] - Sony BDV-E3200 Operating Instructions Manual

x [Auto Standby]
[On]: Turns on the [Auto Standby]
function. When you do not operate the
system for about 30 minutes, the
system enters standby mode
automatically.
[Off]: Off.
x [Auto Display]
[On]: Automatically displays
information on the screen when
changing the viewing titles, picture
modes, audio signals, etc.
[Off]: Displays information only when
you press DISPLAY.
x [Screen Saver]
[On]: Turns on the screen saver
function.
[Off]: Off.
x [Software Update Notification]
[On]: Sets the system to inform you of
latest software version information
(page 41).
[Off]: Off.
x [Gracenote Settings]
[Auto]: Automatically downloads disc
information when you start or stop
playback of the disc. To download, the
system must be connected to the
network.
[Manual]: Downloads disc information
when [Video Search] or [Music Search] is
selected.
x [System Information]
You can display the system's software
version information and the MAC
address.
x [Software License Information]
You can display the Software License
Information.
46
GB

[Network Settings]

x [Internet Settings]
Connect the system to the network
beforehand. For details, see "Step 3:
Preparing for Network Connection"
(page 19).
[Wired Setup]: Select this when you
connect to a broadband router using a
LAN cable.
[Wireless Setup(built-in)]: Select this
when you use the built-in wireless LAN
of the system for wireless network
connection.
Tip
For further details, visit the following
website and check the FAQ:
http://www.sony-asia.com/section/
support
x [Network Connection Status]
Displays the current network
connection status.
x [Network Connection Diagnostics]
You can run the network diagnostic to
check if the network connection has
been made properly.
x [Connection Server Settings]
Sets whether or not to display the
connected DLNA server.
x [Renderer Set-up]
[Automatic Access Permission]: Sets
whether or not to allow automatic
access from a newly detected DLNA
controller.
[Smart Select]: Allows a Sony DLNA
controller to find the system as the
target equipment to operate by using
the infrared ray. You can set this
function to on or off.