Mitsubishi Electric WD-57732 Owner's Manual page 100

100
Appendices
Appendix C: Lamp Cartridge Replacement, continued
WARNING
THE COVER IS PROVIDED WITH AN INTERLOCK TO
REDUCE THE RISK OF EXCESSIVE ULTRAVIOLET
RADIATION. DO NOT DEFEAT ITS PURPOSE
OR ATTEMPT TO SERVICE THE TV WITHOUT
REMOVING THE COVER COMPLETELY.
Removing the Old Lamp Cartridge
1. Turn off TV power and allow the lamp to cool for at
least one hour before proceeding.
2. After the lamp has cooled, remove the cover. Refer
to figure 1. Use a #2 (large) Phillips screwdriver to
remove the two screws securing the cover. Keep the
screws and cover for re-installation
3. With a large flat-blade screwdriver, loosen the two shiny
screws securing the lamp cartridge until they disengage
from the mating threads. These are captive screws and
cannot be separated from the lamp cartridge.
4. Fully open up the bag supplied with the replacement
lamp and set the opened bag aside.
5. Gently grasp the handle of the lamp cartridge and pull
the old cartridge straight out. See figures 1 and 2.
CAUTION: Do not tilt or rotate the cartridge, as
small glass fragments may fall out.
6. Without tilting or putting down the lamp cartridge,
insert it into the opened bag. Close the bag while
being careful not to let any glass particles fall out.
Installing the New Lamp Cartridge
1. Do not touch the glass parts of the new lamp car-
tridge. Insert the new cartridge into the TV using the
following guidelines:
a. Refer to figures 3 and 4 and note the location of
the top and bottom guides inside the lamp com-
partment and the corresponding grooves on the
top and underside of the lamp.
b. Hold the lamp cartridge level with the lamp com-
partment, oriented as shown in figure 5.
c. Align the grooves on the cartridge with the top
and bottom guides in the lamp compartment. See
figure 5.
Guides inside the
lamp compartment
Grooves are on the top and
underside of the lamp cartridge
Figure 3
Handle
(step 5)
d. Carefully push in the cartridge until it is fully
seated. If the cartridge does not slide in
smoothly, gently wiggle the handle from side to
side while pushing in.
2. With either your fingers or the screwdriver, gently
tighten the two shiny screws. If using a screwdriver,
use only two fingers for final tightening. AVOID
OVERTIGHTENING!
3. Replace the plastic cover and retaining screws.
4. WASH YOUR HANDS THOROUGHLY, AS THIS
LAMP CONTAINS MERCURY.
Disposal of the Old Lamp Cartridge
Lamp under warranty: All lamps replaced under war-
ranty must be returned to Mitsubishi. Use the return
shipping label provided and send to Mitsubishi Digital
Electronics, America, 1001 Cherry Drive, Suite 2, Brasel-
ton, GA 30517.
IMPORTANT: Lamps found to be without defect will
be returned and charged back to the sender.
Lamp no longer under warranty: Contact your
Figure 4
local authorities or the Electronic Industries Alliance at
www.eiae.com for lamp-disposal or recycling instructions.
Do not dispose of the old lamp with common trash.
Figure 1.
Figure 2
Guide in lamp
compartment
Figure 5