Download  Print this page

How To Reset The Multiple Cpu System - Mitsubishi Electric MOTION CONTROLLERS Q172DCPU Programming Manual

Melsec q series motion controller.
Hide thumbs

Advertisement

2 MULTIPLE CPU SYSTEM

2.1.5 How to reset the Multiple CPU system

The entire Multiple CPU system can be reset by resetting CPU No.1.
The CPU modules of No.2 to No.4, I/O modules and intelligent function modules will be
reset when PLC CPU No.1 is reset.
If a stop error occurs in any of the CPUs on the Multiple CPU system, either reset CPU
No.1 or restart the Multiple CPU system (power supply ON
recovery.
(Recovery is not allowed by resetting the error-stopped CPU modules other than CPU
No.1.)
POINT
(1) It is not possible to reset the CPU modules of No.2 to No.4 individually in the
Multiple CPU system.
If an attempt to reset any of those PLC CPU modules during operation of the
Multiple CPU system, a "MULTI CPU DOWN (error code: 7000)" error will
occur for the other CPUs, and the entire Multiple CPU system will be halted.
However, depending on the timing in which any of PLC CPU modules other
than No.1 has been reset, an error other than the "MULTI CPU DOWN" may
halt the other PLC CPUs/Motion CPUs.
(2) A "MULTI CPU DOWN (error code: 7000)" error will occur regardless of the
operation mode(All stop by stop error of CPU "n"/continue) set at the "Multiple
CPU setting" screen when any of PLC CPU modules of No.2 to No.4 is reset.
(Refer to Section 2.1.6.)
2 - 5
OFF
ON) for

Advertisement

Table of Contents

   Also See for Mitsubishi Electric MOTION CONTROLLERS Q172DCPU

   Related Manuals for Mitsubishi Electric MOTION CONTROLLERS Q172DCPU

   Related Content for Mitsubishi Electric MOTION CONTROLLERS Q172DCPU

This manual is also suitable for:

Q173dcpu

Comments to this Manuals

Symbols: 0
Latest comments:
  • p Dec 14, 2015 07:47:
    This video describes how to eliminate the 'InS' message on a Mitsubishi Q Series motion controller by ...
  • p Dec 14, 2015 07:32:
    This video describes how to eliminate the 'InS' message on a Mitsubishi Q Series motion controller by