Mitsubishi Electric LT-40148 Owner's Manual page 62

62
6. NetCommand IR Control
Setting Up NetCommand Control of an A/V Receiver, continued
Before You Begin
1.
Connect your A/V devices to the TV and connect
your A/V receiver to the audio outputs on the TV
and the DVD player. See chapter 3, "TV Connec-
tions," for suggestions. Important: To use Setup
1, you must connect the A/V receiver to the TV's
audio output; i.e., the TV's AVR AUDIO OUTPUT or
DIGITAL AUDIO OUTPUT jack.
2.
Position NetCommand IR emitters as described in
"IR Emitter Placement," page 55.
3.
Open the Inputs > AVR menu.
Note: The terms Input1–Input5 used in the AVR menu
are names used by the TV to uniquely identify
A/V receiver inputs.
A
B
C
AV Receiver menu to set up audio switching
A The Learn column lists "learnable" input keys on
the A/V receiver's remote control.
B A check mark next to a key name indicates it has
been "learned" by NetCommand.
C Input1 through Input5 are arbitrary names the
TV uses to uniquely identify A/V receiver inputs.
D After "learning" IR codes for A/V receiver inputs,
use the Assign Input column to identify the device
connected to the TV and the associated A/V
receiver input.
To summarize for the given example:
1.
Connect the TV's audio output to the A/V receiver's
TV audio input.
2. Using this screen, "learn" the IR code for the A/V
receiver's TV audio input as Input1 (item 3 above).
3. In the Assign Input1 column (item 4 above), assign
the name TV Audio (the default) to the A/V receiver
IR code previously learned as Input1.
4. Connect the DVD player's audio output to the A/V
receiver's DVD input.
5. Using this screen, "learn" the IR code for the A/V
receiver's DVD audio input as Input2.
6. Assign Input2 column, assign the name DVD
In the
to the A/V receiver IR code previously learned as
Input2 in this screen.
D
Audio Switching Setup 1: Automatic A/V Receiver
Switching to the TV Audio Input
Most devices are set up like the VCR in this example, in
which analog audio from the device is sent through the TV.
Use this setup for:
• Sources providing only analog stereo output,
such as a VCR.
• Audio from ANT 1 and ANT 2
1.
Learn, highlight Input1.
Under
In this example, the IR code for the A/V receiver's
TV Audio input will be "learned" as Input 1.
2.
Press ENTER on the TV's remote control.
3.
While the text Input1 is flashing, press and hold the
TV INPUT key on the A/V receiver's remote control.
4.
When a check appears next to
TV INPUT key.
• If the text stops flashing before the check mark
appears, repeat this step.
• To erase the IR code just "learned," press
while the name is highlighted.
5.
Press once to highlight TV Audio (TV audio
output) in the Assign Input1 column. The triangular
marker is always next to the assigned sound source.
6.
EXIT if finished or continue with setup for
Press
another TV audio source.
Completed NetCommand setup described for
controlling A/V receiver switching to the A/V receiver's
audio input from the TV's AUDIO OUTPUT.
IMPORTANT
All audio from what you are watching on the
TV is always available from both the TV's AVR
AUDIO OUTPUT and DIGITAL AUDIO OUTPUT
jacks.
To use the digital surround sound capabilities
of your A/V receiver however, you must connect
your DVD player, satellite receiver, or cable box
directly to the A/V receiver, as surround sound
may not be available from the TV's audio output.
Input 1, release the
CANCEL