Stand Alone Configuration Setup - Mitsubishi Electric L423FR Owner's Manual

Stand Alone Configuration Setup

•
Do not remove the stand.
• The Display is heavy. Move it with two or more people.
1. Place the 42" LCD Display on a sturdy surface.
2. Remove the HD-6000 Receiver/Controller from its carton.
3. Place the HD-6000 Receiver/Controller on a sturdy surface.
4. Connect the HDMI™ Cable from the HDMI™ Output connector on the back of the HD-6000 to
the HDMI™/MonitorLink™ INPUT connector located on the back of the LCD Display.
HD-6000 Back Panel (section detail)
5. Connect the USB Cable from the Authorized Card Reader connector on the back of the HD-6000 to
the AUTHORIZED CARD READER connector on the back of the LCD Display.
HD-6000 Back Panel (section detail)
6. Connect the RS-232C Cable from the MonitorLink™ Control RS-232C connector on the back
of the HD-6000 to the RS-232C/MonitorLink™ Control for HD-6000 connector on the back of the
LCD Display.
HD-6000 Back Panel (section detail)
21
CAUTION
LCD Display Back Panel (section detail)
LCD Display Back Panel (section detail)
LCD Display Back Panel (section detail)
When the HD-6000 is connected to the 42" LCD,
the HD-6000 front control buttons are inactive.
To control the HD-6000 (and 42" LCD), set the
remote control to the CABLE/DBS/DTV Layer
or use control buttons located on the side of the
LCD Display.