Specifications; Standard Accessories; Prior To Operation - Hitachi M 8V2 Handling Instructions Manual

PRECAUTIONS ON USING ROUTER
1. Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal
parts of the power tool "live" and shock the
operator.

SPECIFICATIONS

Model
Voltage (by areas)*
Power Input*
Collet Chuck Capacity
No-load speed
Main Body Stroke
Weight (without cord and

standard accessories)

*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Straight Guide .......................................................... 1
(2) Bar Holder ................................................................. 1
Guide Bar .................................................................. 2
Feed Screw ............................................................... 1
Wing Bolt .................................................................. 1
(3) Template Guide ........................................................ 1
(4) Wrench ....................................................................... 1
(5) Wing Bolt (A) ........................................................... 4
(6) Lock Spring ............................................................... 2
Be sure to check standard accessories on product as it is
subject to change by areas.
Standard accessories are subject to change without
notice.
OPTIONAL ACCESORIES - sold separately
(1) Template Guide
A
16.5 mm 18 mm
18.5 mm 20 mm
25.5 mm 27 mm
28.5 mm 30 mm
11000 – 25000 min
Bottom of Sub
base
B C
4.5 mm
2. Single-hand operation is unstable and dangerous.
Ensure that both handles are gripped firmly during
operation.
3. The bit is very hot immediately after operation.
Avoid bare hand contact with the bit for any
reason.
M8V2
(110V, 120V, 220V, 230V, 240V)
1150 W
8 mm or 1/4"
–1
60 mm
3.6 kg
(2) Chuck Sleeve (8 × 6)
20 mm
(3) Trimmer Guide (Fig. 14)
(4) Collet Chuck (8 mm)
(5) Collet Chuck (1/4")
(6) Dust collector set (Fig. 17)
(7) Fine adjustment knob (Fig. 17)
Optional accessories are subject to change without notice.
APPLICATIONS
Woodworking jobs centered on grooving and
chamfering.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. RCD
The use of a residual current device with a rated
residual current of 30mA or less at all times is
recommended.
English
M8SA2
900 W
25000 min –1
3.5 kg
8