Functional Description; Installing Or Removing Battery Cartridge; Switch Action - Makita DJR183 Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.

Installing or removing battery cartridge

1
2
014044
CAUTION:
Always switch off the tool before installing or
•
removing of the battery cartridge.
Hold the tool and the battery cartridge firmly
•
when installing or removing battery cartridge.
Failure to hold the tool and the battery cartridge
firmly may cause them to slip off your hands and
result in damage to the tool and battery cartridge
and a personal injury.
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge fully until the
•
red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not install the battery cartridge forcibly. If the
•
cartridge does not slide in easily, it is not being
inserted correctly.
1. Red indicator
2. Button
3. Battery cartridge
3
Battery protection system
(Lithium-ion battery with star marking)
1
012128
Lithium-ion batteries with a star marking are equipped
with a protection system. This system automatically cuts
off power to the tool to extend battery life.
The tool will automatically stop during operation if the
tool and/or battery are placed under one of the following
conditions:
Overloaded:
•
The tool is operated in a manner that causes
it to draw an abnormally high current.
In this
lever/trigger on the tool and stop the
application that caused the tool to become
overloaded. Then pull the switch lever/trigger
again to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before pulling the switch lever/trigger
again.
Low battery voltage:
•
The remaining battery capacity is too low
and the tool will not operate. In this situation,
remove and recharge the battery.

Switch action

CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the switch lever/trigger
actuates properly and returns to the "OFF"
position when released.
1
2 3
014050
To prevent the switch lever/trigger from accidentally
pulled, the lock-off lever/button are provided.
To start the tool, pull either switch lever or trigger.
5
1. Star marking
situation, release the
1. Lock-off button
2. Lock-off lever
3. Switch lever
4. Switch trigger
4
switch