Mitsubishi Electric F940 Hardware Manual page 24

F940GOT-SWD-E/LWD-E
The figure below shows connection to peripheral units used to create sequence programs.
When built-in two-port interface function is used
F940GOT-SWD-E/LWD-E
Connection cable FX-
50DU-CAB0 for CPU
port connection*1
FX /FX /FX /FX
0 0S 0N
FX Series
2NC
When the two-port interface function is used, the operation environment should be set.
(Refer to the description on "SERIAL PORT" on the SET-UP MODE screen.)
Data transfer cable FX-232CAB-1
(when the RS-232C connector in the personal computer is 9-pin type)
Data transfer cable F2-232CAB-2
(when the RS-232C connector in the personal computer is half-pitch, 14-pin type)
Connected to RS-232C connector in GOT
Connection cable FX-40DU-CAB *1
/ FX/FX
2N 2C
A Series (except QnA)
Motion controller
PC
*1 Connection cables of different length are available.
(Refer to the options in "1.2 Product configuration".)
Series
INTRODUCTION 1.
1
1-16