Battery Installation; Sleep Timer - Mitsubishi Electric WD-52631 Owner's Manual

High-definition television
Hide thumbs Also See for WD-52631:
Table of Contents

Advertisement

Remote Control, continued
1
2
3
4
7
8
9
10
16
17
23
24
25
26 27
28
22
Figure 1. Remote Control Overview

Battery Installation

Figure 2
1. Remove the remote control's back cover by gently
pressing in the tab and lifting off the cover.
2. Load the batteries, making sure the polarities (+) and
(-) are correct. For best results, insert the negative (-)
end first.
3. Snap the cover back in place.

Sleep Timer

Setting the Sleep Timer
1. Press SLEEP on the remote control.
2. Press SLEEP additional times to increase the time in
30-minute increments up to the maximum of 120
minutes.
3. Press EXIT or wait five seconds without pressing any
buttons for the message to disappear.
4. Press SLEEP to view the time remaining before the sleep
timer turns off the TV.
Cancelling the Sleep Timer
1. Press SLEEP to display the on-screen message.
5
2. Press SLEEP repeatedly until OFF is displayed.
Note: After five seconds of inactivity, the message box will
disappear.
1
6
11
12
13
14
2
15
Figure 2. The remote control requires two AA alkaline
18
batteries.
19
Care
20
For Best Results from the Remote Control:
21
• Use only alkaline batteries.
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same time unless
instructed to do so.
• Do not allow unit to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only a soft,
lightly moistened cloth.
• Do not mix old and new batteries.
• Do not heat, take apart, or throw batteries into fire.
Resetting the Remote Control
If the slide switch is set to TV and the TV does not respond
properly, do the following to reset the remote control.
1. Press and hold POWER for several seconds until the button
blinks twice and goes off.
2. Release the POWER button.
3. Press keys 0 0 9 3 5 and the POWER button will blink twice
when you finish entering the code. While entering the
code, pause for a moment between each key press to
ensure it is recognized.
Low-Battery Indicator
If you press a key and the POWER indicator blinks five times,
replace the remote control's batteries.
Chapter 3. TV Operation
35

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd-57731Wd-65731Dlp wd-52631Dlp wd-57731Dlp wd-65731

Table of Contents