before using your Kenwood
Read these instructions carefully
and retain for future reference.
Remove all packaging and any
Watch out for steam, never
lift the tank lid during the
Never touch the hotplate or
Always lift the lid using the
tab at the front
Do not touch hot parts.
Never let the cord hang down
where a child could grab it.
Never use a damaged appliance.
Get it checked or repaired: see
'service and customer care'.
Never put the appliance in water or
let the cord or plug get wet - you
could get an electric shock.
before filling with water
Never leave the appliance on
Do not let the cord touch hot parts.
Always make sure there is water in
the tank before switching on.
This coffee maker is only suitable
for use with the type of carafe
Do not leave the appliance
switched on with an empty carafe
on the hotplate.
Never put the carafe in the
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
ensure that they do not play with
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper
use, or failure to comply with these
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your appliance.
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for the first time
1 Wash the parts: see 'care and
2 Run two full tanks of water (without
coffee) through the coffee maker to
clean it out. See 'to make coffee'.
water tank (750 mls)
on/off button with indicator
to make coffee
1 Lift the lid using the tab
front of the coffee maker.
2 Fill the tank with the desired amount
of water. The water level must be
between the 2 and Max mark. Do
not fill above the MAX level.
Use cold water. We recommend
using filtered water as it reduces
limescale and prolongs the life of
your coffee maker. Never use warm
or fizzy water.
3 Ensure the filter holder is positioned