Notes On Use With Windows Server 2008/Windows Server 2012 - Canon VB-S30D Operating Manual

Click [Trusted sites] > [Sites].
3
The [Trusted sites] dialog box appears.
Enter the IP address of the camera under [Add this
4
Web site to the zone], then click [Add].
Note
• Clear the [Require server verification (https:) for all sites in this
zone] check box if it is selected. The camera's IP address will
be registered to the [Websites] list.
• You can register IP addresses for multiple cameras by using a
wildcard (*) when entering the IP address. For example, if you
enter "192.160.1.*", all cameras that share the "192.160.1"
portion of the address will be registered as trusted sites.
20
Notes on Use with Windows Server 2008/
Windows Server 2012
Registering "about:internet" and the
Camera Host Name
Admin Viewer and Admin Tools will not start when IE ESC
(Internet Explorer Enhanced Security Configuration) is
enabled in Windows Server 2008/Windows Server 2012.
Before using the tools, register "about:internet" and the
host name for the connected camera in the Internet
Explorer "local intranet" and "trusted sites" lists.
Important
When "about:internet" is registered, the security level in
Windows 7 is the same as when using Internet Explorer. After
using the Admin Viewer/Admin Tools, it is recommended that
you remove "about:internet" and the camera name as
necessary and restore the original security level.
Web Browser Security Settings When Using
SSL Connection
When an SSL connection to the camera is made from a
web browser (Internet Explorer 9/10/11) in Windows
Server 2008/Windows Server 2012, the following
operations may display the content block dialog box and
prevent further operation.
• Startup of Admin Tools or Admin Viewer
• Audio reception from VB Viewer
This happens when Internet Explorer Enhanced Security
Configuration (IE ESC) is enabled in Internet Explorer 9/
10/11. Use the procedures below to change this setting.
Click [Internet Options] in the [Tools] menu in Internet
1
Explorer 9/10/11 and click the [Advanced] tab.
Clear the [Do not save encrypted pages to disk]
2
checkbox in [Security].