Instructions for Connecting Piping to
Outdoor Unit
1. Unscrew the cover from the packed valve on
the side of the outdoor unit. (See Fig. 5.9 )
Fig. 5.9
2. Remove protective caps from ends of valves.
3. Align ared pipe end with each valve, and
tighten the are nut as tightly as possible by
hand.
4. Using a spanner, grip the body of the valve.
Do not grip the nut that seals the service
valve. (See Fig. 5.10 )
Page 28
USE SPANNE R TO GRIP MAIN
BOD Y OF VALVE
Torque from tightening the are nut can snap
o other parts of valve.
Valve cover
5. While rmly gripping the body of the valve,
use a torque wrench to tighten the are nut
according to the correct torque values.
6. Loosen the aring nut slightly, then tighten
again.
7. Repeat Steps 3 to 6 for the remaining pipe.
Fig. 5.10