Bromic Heating TUNGSTEN SMART-HEAT User Manual page 2

IMPORTANT
!
This manual contains important information about the installation, and operation of Tungsten
Electric controller. Please pay close attention to the important safety information shown
throughout this instruction manual. Any safety information will be accompanied by the following
• READ THIS MANUAL CAREFULLY before installing or
• Improper installation or operation can result in death, severe
• Use this controller only as described in this manual. Any other
• This controller is intended for fixed installation with 110 - 230
• Installation MUST be carried out by a licensed and authorised
• For Commercial Use Only
WARNING
!
• WARNING: The outputs are NOT protected against short circuits or extra-currents which can damage the electronic board.
Evaluate the characteristics of the connected loads and apply the appropriate safety devices to the power line.
• The radio signal reception of the device can be affected by the presence of electrical disturbances being transmitted by other
appliances working on the same frequency or if the product is shielded by metal parts.
• Do not use the remote in places where systems are sensitive to radio emissions.
• Do not keep or use the remote in places that are damp, where there is steam, high air humidity, dust or where it is exposed to
direct sunlight or similar environmental conditions.
• Do not drop the remote. This could damage or reduce the range of action of the remote.
• Do not use your nails to press remote buttons.
• Keep remote batteries out of reach of children.
• Call a doctor immediately if a battery is swallowed.
• See remote instruction manual for more details on the included remote.
Telephone: 1300 276 642 (within Australia) or +61 2 9748 3900 (from overseas) Fax: +61 2 9748 4289
Note: Bromic Heating reserves the right to make changes to specifications, parts, components and equipment without prior notification.
This Installation, operation and service manual may not be reproduced in any form with prior written consent from Bromic Heating.
Manufactured by Teleco Automation s.r.l. - Italy - www.telecoautomation.com
2
safety alert symbols:
DANGER,
!
servicing this product.
injury, or property damage.
use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons
volt power supply.
technician in accordance with local electrical codes.
NOTE: IMPORTANT INSTRUCTIONS, SAVE THESE
Head Office: 1 Suttor Street, Silverwater, Sydney, NSW 2128 Australia
Email: info@bromicheating.com Web: www.bromicheating.com
WARNING, IMPORTANT
! !
INSTRUCTIONS
BROMIC HEATING
www.bromicheating.com