Osmio Ecopure Eco-8 Installation Instructions

Ecopure Eco- - - - 8 8 8 8 Water Filter Installation Instructions

Ecopure Eco

Water Filter Installation Instructions

Ecopure Eco

Water Filter Installation Instructions

This tutorial explains how to fit the Ecopure Eco-8 filter.

The Ecopure Eco-8 is designed to filter all the water supply a cold water tap or refrigerator and any

cold water 15mm pipe.

Fitting your new filter

First you need to turn off your cold water supply and drain down by turning on the taps. If you are

unsure, then get a qualified plumber of handyperson to come in and do the job.

The in and out fittings are 15 mm 'push fit' fittings so ensure that you use push any 15 mm (copper

or plastic/speedfit) pipe. You need to cut your cold water 15mm copper pipe and place the filter

into the gap - so that it sits "in-line".

It is recommended to fit a small length (about 6-10cm) of copper pipe to fit to the compression

fitting on a flexible hose as shown below.

This makes filter changes much easier.

Call

Call 0800 002 9533 or

Call

0800 002 9533 or visit www.osmiowater.co.uk

0800 002 9533 or

visit www.osmiowater.co.uk

Table of Contents

Do you have a question about the Ecopure Eco-8 and is the answer not in the manual?

Page 1 Water Filter Installation Instructions This tutorial explains how to fit the Ecopure Eco-8 filter. The Ecopure Eco-8 is designed to filter all the water supply a cold water tap or refrigerator and any cold water 15mm pipe. Fitting your new filter...
Page 2 The copper pipe then needs to be pushed into the black 15mm push fittings. Ensure they are in completely and firmly, you should feel them slide into place if done correctly. The filter has a flow arrow pointing in the direction of the water flow. This indicated where the “in” and “out”...