Husqvarna TE 250R 2013 Operation And Maintenance page 25

THROTTLE CABLE ADJUSTMENT
To check the correct adjustment of the throttle operate as fol-
lows:
- Remove rubber caps (1);
- by moving the opening cable (2) back and forth, check that
free play is 3 mm;
- by moving the closing cable (3) back and forth, check that free
play is 1 mm;
- if it does not happen, loosen the nut (4) and appropriately
turn the adjuster screw (5);
(loosen it to decrease clearance, tighten it to increase it);
- after adjustment block the nut (4).
WARNING*: Operation with damaged throt-
tle cable could result in an unsafe riding con-
dition.
WARNING*: Exhaust gas contains poisonous
carbon monoxide gas. Never run the engine
in a closed area or in a confined area.
4
5
4
5
EN - 24 SPECIFICATIONS - OPERATION - MAINTENANCE
ADJUSTING THE IDLE
Adjust the carburetor with warm engine and with the throttle
control in closed position. Proceed as follows:
- turn the knob (1) on the left side of the throttle body of about
34 clicks from the fully closed position, checking with the suit-
able device that revs are of about 1,950 RPM (turn clockwise
to increase the speed and counter clockwise to reduce it).
2
1
3
1