Replacing Carbon Brushes - Makita DLS713 Instruction Manual

2. Bevel angle
(1) 0° bevel angle
Push the carriage toward the guide fence and
tighten two clamp screws to secure the
carriage. Lower the handle fully and lock it in
the lowered position by pushing in the stopper
pin. Loosen the lever at the rear of the tool.
Turn the 0° bevel angle adjusting bolt (lower bolt)
on the right side of the arm two or three revolutions
counterclockwise to tilt the blade to the right.
2
012589
Carefully square the side of the blade with
the top surface of the turn base using the
triangular rule, try-square, etc. by turning the
0° bevel angle adjusting bolt clockwise. Then
tighten the lever securely.
1
001819
Make sure that the pointer on the arm point to
0° on the bevel scale on the arm holder. If it
does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so
that it will point to 0°.
1
2
011306
1. Lever
1
2. Arm holder
3. 0 ﾟ degree
bevel angle
adjusting bolt
4. Arm
5. Release button
5
4
3
1. Triangular rule
2. Saw blade
3. Top surface of
2
turn table
3
1. Bevel scale
3 2. Pointer
3. Screw
(2) 45° bevel angle
012590
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure
that the pointer on the arm points to 45° on the
bevel scale on the arm holder. If the pointer
does not point to 45°, turn the 45° bevel angle
adjusting bolt (upper bolt) on the right side of
the arm until the pointer points to 45°.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
011307
After replacing brushes, install the battery cartridge and
break in brushes by running tool with no load for about
10 minutes. Then check the tool while running and
electric brake operation when releasing the switch
trigger. If the electric brake is not working correctly, have
the tool repaired by a Makita service center.
20
1. Left 45 ﾟ bevel
angle adjusting
bolt
1
1. Limit mark
1
1. Brush holder
cap
1
2. Screwdriver
2