Remote Receptacle Information - Miller Electric Legend 301 G Owner's Manual

5-8. Remote Receptacle Information

NOTE
A A J J
K
I
B
C L N
H
M M
D D G G
F
E
Notes
OM-4411 Page 20
Engine runs at weld speed (3000 or 3600 rpm) whenever a device connected to
the remote receptacle is running.
24 VOLTS AC
115 VOLTS AC
A/V A/V
AMPERAGE
VOLTAGE VOLTAGE
GND GND
*The remaining sockets are not used.
Socket* Socket Information
A 24 volts ac. Protected by circuit breaker CB5.
B Not used.
I 115 volts ac. Protected by fuse F2
J Not used.
C Output to remote control: 0 to +10 volts dc output
to remote control in Stick and TIG modes. +10
volts dc output to remote control in Wire mode.
D Remote control circuit common.
E DC input command signal: 0 to +10 volts dc from
min. to max of remote control with front panel V/A
control at max.
G Circuit common for 24 volt ac circuits.
K Chassis common.