Water-Cooled Gun Connections - Miller Electric XR A Owner's Manual

Wire feeder and feeder gun
Table of Contents

Advertisement

4-7. Water-Cooled Gun Connections

OM-1581 Page 14
4
5
Left Side
9
3
2
1
6
3
7
8
Tools Needed:
5/8, 1-1/8 in
1
Gas Hose
Connect to Gas fitting on feeder.
2
Water Hose
Connect to water to gun fitting on
feeder (left-hand threads).
3
Wire Conduit
4
Thumbscrew
5
Wire Conduit Block
Loosen thumbscrew, and insert
conduit through Wire opening until
it bottoms against block. Trim liner
if necessary, as close to the rolls
as possible. Tighten thumbscrew.
6
Gun Control Cable
Insert plug into gun control recep-
tacle, and tighten threaded collar.
7
Strain Relief
Remove strain relief as shown.
8
Power/Water Cable
9
Strain Relief
.
For guns that have wire con-
duits with replaceable liners,
the strain relief will need to be
removed from the control box.
Route cable through strain relief
and connect to weld/water from gun
outlet on feeder. Reinstall strain re-
lief. Close and latch door.
Ref. 802 536-E / Ref. 151 778-B / 152 456-A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xr w

Table of Contents