Download  Print this page

Viking VCSB5481 Series Technical Information Page 17

Hide thumbs

Advertisement

A WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing.
SPECIFICATIONS
Mold heater 185 watts, 264 ohms
Thermostat closes 17° ± 3° F (-8° ± 1° C)
Bimetal opens at 32° + 3" F (0°+ 1" C)
Water fill is 140cc, 7.5 seconds
Motor cycle, stamped in circuit
Plug in connectors
One revolution of blades takes 3 minutes
plus stall time on ice (eject and water fill).
Module Ohmmeter Checks No power to icemakerand Ejector blades in end of
cycle
Test Points
Component
Module Position
Ohms
L-H
Mold & Heater
Attached to support
264
L-M
Motor
Separate from heater
16,100
Module Voltage checks with motor or test light power to icemaker
!Test Points
Component
Line Voltage
0 Volts
L-N
Module
Power On
Power Off
T-H
Bimetal
Open
Closed
L-H
Heater
On
Off
L-M
Motor
On
Off
N-V
Water valve
On
Off
Water fill adjustment screw
If water fill is inadequate, less than 140cc,
it can be increased by turning the water fill
adjustment screw (see photo to left) in a
counterclockwise direction. If water fill is too
great it can be decreased by turning screw in
a clockwise direction.
One half turn will adjust the fill by approxi
mately two thirds of an ounce.
17

Advertisement

Table of Contents

   Related Manuals for Viking VCSB5481 Series

This manual is also suitable for:

Fdsb5481 series

Comments to this Manuals

Symbols: 0
Latest comments: