Pull the coupling [A] out of the right balancer [B].
Take the one-way clutch [C] out of the coupling.
Starter Clutch Gear [D] (for reference)
Install the one way clutch [A] so that its groove [B] faces
outward and its flange [C] fits between the right balancer
[D] and the coupling [E].
Apply a non-permanent locking agent to the threads of the
coupling bolts, and tighten them to the specified torque.
Torque - Starter Clutch Coupling Bolts: 15 N·m (1.5 kgf·m,
Special Tool - Flywheel Holder: 57001-1313
Remove the starter clutch gear [A] and torque limiter, then
reinstall the starter clutch gear into the starter clutch.
Turn the starter clutch to both side.
When viewed from the right side of the engine, the clutch
should turn clockwise [B] freely, but should not turn coun-
If the starter clutch does not operate as it should or if it
makes noise, disassemble the starter clutch.
If one-way clutch [A] installation is wrong, reinstall it.
Visually inspect the one-way clutch, coupling and starter
clutch gear for damage.
If there is any worn or damaged surface in the following
parts, replace it.
Sliding Surface [B] and Cage of One-way Clutch
Sliding Surface [C] of Starter Clutch Gear
Sliding Surface [A] of Coupling