Important Safety Instructions - Wen 56200i Instruction Manual

WARNING: This generator produces heat when running. Temperatures near exhaust can exceed 150
F (65 0 C).
Do not touch hot surfaces. Pay attention to warning labels on the generator identifying hot parts of the
machine.
Allow generator to cool down after use before touching engine or areas of the generator that become
hot during use.
CAUTION: Misuse of this generator can damage it or shorten its life.
Only use generator for its intended purposes.
Operate only on dry, level surfaces.
Allow generator to run for several minutes before connecting electrical devices.
Shut off and disconnect any malfunctioning devices from generator.
Do not exceed the wattage capacity of the generator by plugging in more electrical devices than the unit can
handle.
Do not turn on electrical devices until after they are connected to the generator.
Turn off all connected electrical devices before stopping the generator.
Turn the engine switch to "OFF" position when the engine is not running.
SAVE THESE INSTRUCTIONS – This manual contains important instructions for the WEN
generator that should be followed during installation and maintenance of the generator.
Generators vibrate in normal use. During and after the use of the generator, inspect botht he generator as well as
extension and power supply cords for damage resulting from vibration. Have damaged items repaired or replaced
as necessary. Do not use plugs or cords that show signs of damage such as broken or cracked insulation or dam-
aged blades.
For power outages, permanently installed stationary generators are better suited for providing backup power to the
home. Even a properly connected portable generator can become overloaded. This may result in overheating or
stressing of the components, possibly leading to a generator failure.
WARNING: If this generator is used as a supply for a building's wiring system, the generator must be installed
by a qualified electrician and connected to a transfer switch as a separately derived system in accordance with
the National Electrical Code, NFPA 70. The generator shall be connected to a transfer switch that switches all
conductors excluding the equipment grounding conductor. The frame of the generator shall be connected to an
approved grounding electrode.
6
GENERAL SAFETY PROCEDURES

IMPORTANT SAFETY INSTRUCTIONS

0
2000W inverter
®