Download Print this page

AGPtek 200W User Manual

Gti grid series

Advertisement

Quick Links

- 1 -
GTI Grid Series
GTI Series Inverters For Grid
User Manual
1

Advertisement

loading

Summary of Contents for AGPtek 200W

  • Page 1 - 1 - GTI Grid Series GTI Series Inverters For Grid User Manual...
  • Page 2: System Function

    - 2 - GTI Grid Series System Function  Directly connected to the solar panels (do not need to connect the battery) Using precise MPPT function, APL functions, the inverter automatically adjust the solar panels of maximum output power,simply connect the solar panel to the grid inverters. Do not need to connect the battery.
  • Page 3: Parameter Table

    - 3 - GTI Grid Series Parameter Table Grid-series models 200W 300W 400W 500W 600W 800W 1000W Recommend use solar panels 320Wp 420Wp 520Wp 620Wp 720Wp 1050Wp 1250Wp DC Maximum Input Power 300W 400W 500W 600W 700W 900W 1200W DC maximum voltage VpvDC30.2VDC...
  • Page 4: Installation Instruction

    - 4 - GTI Grid Series Installation instruction Figure 1 1、Please read the below notes carefully before installation. A) Make sure the open voltage and operation voltage is in the range of 10.5-28V, and we recommend the 18V rated voltage solar panel or 24V battery. B) Make sure the inverter’s AC voltage and frequency is the same with power grid voltage and frequency.
  • Page 5 - 5 - GTI Grid Series Figure 2 3、Connection of AC terminal Before connect the inverter’s AC cable to the socket, you must disconnect the utility power. Then put the AC cable which has holes terminal into the inverter’s 3 feet port and the pin terminal to the socket.
  • Page 6 - 6 - GTI Grid Series Show as figure 4: Figure 4 6、Single-phase connection Connection electrical diagram of the solar inverter used in single-phase power generation system, show as below:...
  • Page 7 - 7 - GTI Grid Series 7、 Three-phase connection Connection electrical diagram of the micro inverter used in three-phase generation system, show below:...
  • Page 8 - 8 - GTI Grid Series 8、Trouble shooting 1)Red LED shows: A、Check if the input voltage to inverter is lower than 10.5V or higher than 28V. B、Check it the AC cable connect to utility power correct or the utility power is disconnect. 2)No LED shows: A、Check if the DC input voltage is in too low.

This manual is also suitable for:

300w400w500w600w800w1000w