Scanner Exit Window; Connector; Cleaning Cradle Connectors - Motorola MC75A User Manual

8 - 4 MC75A Enterprise Digital Assistant User Guide

Scanner Exit Window

Wipe the scanner exit window periodically with a lens tissue or other material suitable for cleaning optical material
such as eyeglasses.

Connector

Remove the main battery from mobile computer. See
1.
Close battery door.
2.
Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3.
Rub the cotton portion of the cotton tipped applicator back-and-forth across the connector on the bottom of the
4.
MC75A. Do not leave any cotton residue on the connector.
Repeat at least three times.
5.
Use the cotton tipped applicator dipped in alcohol to remove any grease and dirt near the connector area.
6.
Use a dry cotton tipped applicator and repeat steps 4 through 6.
7.
Do not point nozzle at yourself and others, ensure the nozzle or tube is away from your face.
CAUTION
Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away from the surface.
8.
Inspect the area for any grease or dirt, repeat if required.
9.

Cleaning Cradle Connectors

To clean the connectors on a cradle:
Remove the DC power cable from the cradle.
1.
Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
2.
Rub the cotton portion of the cotton tipped applicator along the pins of the connector. Slowly move the
3.
applicator back-and-forth from one side of the connector to the other. Do not let any cotton residue on the
connector.
All sides of the connector should also be rubbed with the cotton tipped applicator.
4.
Do not point nozzle at yourself and others, ensure the nozzle or tube is away from your face.
CAUTION
Spray compressed air in the connector area by pointing the tube/nozzle about ½ inch away from the surface.
5.
Ensure that there is no lint left by the cotton tipped applicator, remove lint if found.
6.
If grease and other dirt can be found on other areas of the cradle, use lint free cloth and alcohol to remove.
7.
Allow at least 10 to 30 minutes (depending on ambient temperature and humidity) for the alcohol to air dry
8.
before applying power to cradle.
If the temperature is low and humidity is high, longer drying time is required. Warm temperature and dry
humidity requires less drying time.
Replacing the Main Battery on page 1-9.