Gas Section - Kenwood KHG 601 Instructions For Use Manual

5 - GAS SECTION

GAS SUPPLY REQUIREMENTS
Important Note
This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation
label attached on the appliance).
– Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only
and cannot be used on any other gas (LPG) without modification. The appliances are
manufactured for conversion to LPG.
– Appliances supplied for use on LPG: they are adjusted for this gas only and cannot
be used on any other gas (NATURAL GAS) without modification. The appliances are
manufactured for conversion to NATURAL GAS.
If the NATURAL GAS/LPG conversion kit is not supplied with the appliance this kit can be
purchased by contacting the After-Sales Service.
Installation and Service Regulations (United Kingdom Only)
This appliance must be installed and serviced only by a suitably qualified and registered
person, and in accordance with the current editions of the following standards and regula-
tions or other locally applicable regulations:
– Gas Safety (Installation and Use) Regulations
– Building Regulations
– British Standards
– Regulations for Electrical Installation
Installation and service of any gas product must be made by a suitably qualified person
competent on the type of product being installed or serviced and holding a valid certificate
of competence for the work being carried out. Currently the proof of competence is the
Accredited Certification Scheme (ACS) or S/NVQ that has been aligned to the ACS.
It is also a requirement that all businesses or self employed installers are members of a
class of person approved by the Health and Safety Executive.
Failure to install the appliance correctly could invalidate any manufacturers warranty and
lead to prosecution under the above quoted regulation.
16