Toshiba B-852-TS12-QP Owner's Manual page 30

3. PRINTER OPERATION
3.2 Operating Modes
(cont.)
CAUTION!
• Be sure to cut the
backing paper of label.
Cutting labels will
cause the glue to stick
to the cutter, which
may affect the cutter
quality and shorten the
cutter life.
• Use of tag paper when
the thickness exceeds
the specified value
may affect the cutter
life.
NOTE:
Cut mode is available only when
the optional cutter module (B-
7208-QM) is installed.
2. Continuous (or batch) mode – In this mode, the labels will be
continuously printed and fed until the number of labels specified in
the label issue command has been printed. After the last label of the
series has been printed the labels can be torn free from the supply
roll in a similar manner as described in the tear off mode above.
3. Cut Mode - In the cut mode, as each label is printed it is fed forward
to the Cutter Mechanism where the swing cutter mechanism will
precisely cut the label off from the supply roll. The feed mechanism
will then backfeed the label or tag stock until it is properly
positioned under the Print Head to print the next label in series. The
issue command sent to the printer from the Host can inform the
printer to cut each label or tag after each has been printed or to
perform the cut only after a certain number of labels or tags have
been printed and issued.
E3- 2
ENGLISH VERSION EO1-33028
3.2 Operating Modes